Import/Export with unimesh mess up the bones assignment?

[montoto_sk]

Hi everybody, I'm new in meshing so I need some help. When I import (and export) custom meshes in milkshape the bone assignment mess up, even if I don't change anything. There is a way to solve this?

I use milkshape 1.7.9 with Unimesh V4.09,

Meshes extracted with Simpe 0.68 Alpha.

Thank you.

[WesHowe]

SimPE 0.68?
Where did you get that? I have 0.64 as being the latest.

<* Wes *>

[bLURR]

so have i
gimme gimme gimme :D

[Nouk]

I had the same problem, because I was using an earlier simpe test version. If you have acces to the QA forum, I suggest you get the newest version posted there. Or, get Inge's very newest version, I think they're the same thing, not sure.

[Inge Jones]

0.64.5c and the self-installing release are the same actual code built, but packaged up differently and with different config and doc files.

[WesHowe]

I had the same problem, because I was using an earlier simpe test version. If you have acces to the QA forum, I suggest you get the newest version posted there. Or, get Inge's very newest version, I think they're the same thing, not sure.

Wasn't the last QA version numbered 0.63.8 (63h)? If so, then listen to Nouk.

[montoto_sk]

Hi everybody! Thanks for your messages!

Yes, is not 0.68, is 0.62, Sorry about that! :rofl:

Anyways I think the problem wasn't SimPe, the problem was the Unimesh plugin. Because I go back to the 4.05 version (With the old Milkshape 1.7.8) and everything is OK!

Thank you all, see you!