- you can make pretty dormers like in this and this house -- see below for additional info on this (added 2008-11);
- you can use the top level for split-level stairs (see this and this house);
- doors and windows often look better when they have some space above (instead of being glued to the ceiling and partly covered by the roof);
- since it's enclosed by real walls, the attic will be Seasons-proof.
This tutorial covers three different topics:
1. Bigger Attics (below)
2. Bigger Attics and Dormers (scroll down) -- added on 2008-11-02
3. Barn Roofs with Bigger Attics (scroll down more) -- added on 2008-11-19
Part 1: Bigger Attics
This is not very difficult, if you look at picture 6 it may even be self-explaining. I just thought I'd post a tutorial anyway, since I never see anybody else using this method and I find it very useful.
No expansions required. Be careful with the constrainfloorelevation cheat in an unpatched OfB game if you use stages: trying to level a stage will crash to dektop. This was fixed with the OfB patch and with later EPs.
Here's how it works:
(If you already know how to make a wall 6 clicks high, you can skip to step 4)
Build a box that's two levels high; make a little hill next to it that's two clicks high.
On top of the hill, build a two-story foundation (or a regular foundation with a wall on top, doesn't make a difference)
Enter the cheat "boolprop constrainfloorelevation false" (may require capitalisation; for me it doesn't).
From the top of your foundation-on-the-hill, flatten the top level of your house-to-be with the terrain levelling tool (you can also use floor tiles for this). Important: you need to pull the levelling tool (or the floortiles) FROM the thing on the hill TO the opposite side of the house, not the other way around.
This is how it should look like: a ground floor with regular walls, and a top floor that's only 6 clicks high. Put a 45° roof on top of the whole thing.
Now go to the top floor (below the roof) and build a wall box *inside* the short walls like shown (with 2 tiles space in between) -- this will pull the walls on the sides of the house up to regular height, and that's the whole trick.
Same thing in colour, to show the principle more clearly: the difference in height between the short walls on the outside and the regular walls on the inside is 10 clicks, and a two tile wide roof is high enough to cover that. Without the short walls, you'd need 3 tiles on each side for the roof, leaving only two for the attic.
From here on out, you can either just put windows in the side walls and be done with it, or proceed to add dormers etc. Remember to switch off the floorelevation cheat (enter "boolprop constrainfloorelevation true") when you're done.
The dummy level doesn't have to be exactly 6 clicks high btw -- if it's less high, you need a steeper roof, if it's higher, you can make the roof flatter.
Addendum: Dormers -- 2008-11-02
I'm adding this because I've been having lots of fun with Bigger Attics and dormers – a combination that turns almost the entire roof space into useable space, while the house can still be cute and tiny. Particularly useful in the Base Game with its one fixed roof angle, where almost any roof will be a giant blob at first .. why not make good use of that space?
Version 1: Gabled dormers
You can also use this method for shed roof or flat roof dormers, the principle is always the same (only hipped roofs don’t work, due to the brokenness of the game). These are very simple, they work just like regular dormers – the only problem is that the short walls will slant up, and we need to get rid of that slant somehow. Three solutions below.
Proceeding from step 6 above, make a little box for your dormer:
Then remove the offending bits of wall:
There's a few different ways to fill in the gaps:
Solution 1 (NL, OfB, and other EP-that-has-halfwalls users): Close the gaps with a half wall (preferrably one with no frills on top, so that nothing will stick through the roof).
Solution 2 (anyone): Use a matching fence to close the gap. There's probably custom ones, or try the stone walls from the Base Game if your house happens to be a matching colour -- example here (Newbie Road 89; I've used the grey "stone wall" fence all along the side for this).
Solution 3 (anyone): Close the gap with a roof wall – with a shed roof you can put roof walls pretty much anywhere you want.
In this case, put a shed roof to the left and right of the dormer – on the floor level, not the roof level (one level below the actual roof, that is):
Note that it depends on the direction of your lot which way the shed roof will turn -- if the sun is in front right (or back left) of the lot, it'll have to be two tiles wide in order to be perpendicular to the street.
If you have Seasons or later, you can adjust the height of that roof wall with the "individualroofslopeangle" cheat so that it's exactly the same as your short support walls ( = additional neatness). In the Base Game, you can't -- but it doesn't really matter as the overhang of the main roof will hide the top edge of the support walls anyway .. so even if the height is a little off, you don't really see it.
Then put a roof on top of your dormer – this is what it should look like:
(the grey bits are the newly added roof walls)
Proceed to add windows and stuff … voilà, cute house with useable attic *and* dormers. You can look at Newbie Road 159 and later (see my profile) for plenty of examples of this method in action.
Note that neither halfwalls nor fences nor roof walls are Seasons-proof (to my knowledge) – rooms that are (partly) enclosed by those, and not 100% by actual walls, will have outdoor temperature in Seasons. You could conceivably turn those spaces into real simulated attics (hot in the summer, cold in the winter) but I would not suggest to put bedrooms in there.
Version 2: Sloped-floor-roof dormers
Here we don't remove the slanted walls, but pretend they're meant to look like that.
You need to go back to step 3 or 4 for this (before pulling up the inside walls). Put some convincingly roof-like flooring where you want your dormer to be, and on the tiles directly left and right of it; also add some decorative edging if you like:
Then put on your roof:
After that, pull up your inside walls (i.e. make two boxes .. one for the main attic, one for the dormer):
This is how it looks like from the outside:
Inside, for example:
Note that anything below a sloped floor is not Seasons-proof, even if the surrounding wall is a real wall. However, in this case there is *also* a roof (the main roof) where the slanted bits are, so I'm assuming it's weatherproof anyway (I haven't tested this though).
Also, note that you can see the main roof through the dormer window (because it has no roof above it, as far as the game is concerned) – a non-see-through curtain helps greatly to obfuscate that.
More addendum: Barn Roofs with Bigger Attics -- 2008-11-19
Pets or higher is required for this -- and if you only have Pets it needs to be patched (the individualroofslopeangle cheat was broken originally and only got fixed with the patch)!
Those sometimes look better (at least on non-foundation houses) than regular barn roofs -- and they're bigger inside, so here's another quick how-to:
Proceed from step 3 above: make a two-story box with a full-height ground floor and a six-click-high top floor -- it can also be four clicks or five or seven, whatever looks best for your purpose
Put two bits of shed roof on the front and back row of tiles (this will be the steep part of the roof) -- and then enter the cheat
The exact angle depends on how high your support walls are, and also a little bit on the angle of the roof on top -- 57.6° works for six clicks and a 25° top roof; you might need to fiddle a bit until you hit the sweet spot where the roof doesn't stick out on top and leaves no gap either. Note that you need to enter float numbers with a decimal point, not a comma! (This may depend on your game language -- I've always played the game in en-US, so I don't know)
Then pull up your inside walls to full height (you can't do this earlier, since roofs can't be placed on a slope)
Now put a gable roof on top of your house -- it will be the wrong angle at first, enter
individualroofslopeangle 25 (or 15, or 20, or 30 .. whatever looks good)
and then alt-ctrl-click on the gable roof -- it will snap down to the flatter angle.
The side walls of the shed roofs will probably stick out at a funny angle now -- you can delete them with the wall tool. (You can also remove the inner walls, which are now reduced to a thin line on top of the actual inside walls .. if you are a perfectionist .. but they do no harm, so you can just as well ignore them)
The result looks like in the first pic above -- steep roofs on the sides, with a flat bit on top. That's all you need for a barn roof, there's no special tool required or anything. You can certainly also build a house with a Bigger Attic and a barn roof *and* dormers -- see Newbie Road 143 for an example of that.
Remember to turn off the cfe cheat when you're finished:
boolprop constrainfloorelevation true
That's it. Have fun!
I read all the comments you leave, even if they are made a year later, thank you all:)
Any lot building requests are considered, just pm me:)
Thanks: 1482 in 10 Posts
(The other foundation -- the one on top -- is the same height as a regular wall, 16 clicks)
Just a regular person
By default, dormers will look like on this house: http://www.modthesims2.com/showthread.php?t=137367 -- the main difference being the slanted wall and the fact that the roof is 6 (or so) clicks higher up ... so if you make a dormer just one tile inside the outside wall, most of it will be covered by the roof.
You can get rid of the slant by replacing parts of the short wall with halfwalls, and have you tried to incorporate the dummy level into the dormers as well (make a two-level dormer in other words)?
Just a regular person
And you should put in some flooring, it's a lot easier to see what you're doing =) (and it should prevent the "needs sth to support it" message)
Lastly, with a house of the size that's shown in the screenshots I wouldn't bother with this method at all ... there's plenty of space for two attics, even without any tricks. Or is this just a test house to try and see how it works?
Edit -- Oh, another thing: in case you post screenshots again, can you paint the walls a bit (at least one of the levels, like in the last pic of my first post)? I *think* your walls are OK, but it's hard to see when everything is the same grey.
I have the cheat on and I still get "can't intersect walls". I appreciate your help.
Just a regular person
Nothing wrong with your walls and levels it seems, thanks for the 2nd picture.
Just a regular person
Thanks: 12436 in 47 Posts
Thanks: 29 in 2 Posts
"In dreams begins responsibility."
- William Butler Yeats, "Responsibilities"
Thanks: 78 in 3 Posts
|We make a living by what we get, but we make a life by what we give. (Winston churchill)|
Thanks to all you hardworking modders.
Thanks: 10573 in 115 Posts
A. build feature tutorials/hints/tips:
roof Attic walls
1. weather-related (snow, hail, rain, outside or inside)
attics in seasons [abel1980]
Info box indicating weather state @ build mode
seasons and roofing
Sims freezing in a Maxis house
2. cheat helps:
RESOURCE: Helpful roof slope angles
3. build feature helps:
How Do I Make This Roooooof?
Roof Won't Fit?? Help anyone?
%$%*$( ROOF &(*&*__^$
can somebody help me ?? because i want to do that under a one level house but i think it can't ? can somebody explain ?
? hello people were can i get some help sombody that can explain me how to make this on a 1 level house , im not a good builder , if here someone that know how to do that please send me a mail then ? please