#2
4th Jun 2020 at 2:30 PM
Last edited by vegan_kaktus : 4th Jun 2020 at
5:07 PM.
Posts: 830
Thanks: 3476 in 56 Posts
11 Achievements
I'm not sure if it's possible to make working custom mailboxes (and if it where, you'd have to animate the "hatch", is it called a hatch?? I mean the "door" on the mailbox) but overlays are totally possible! Parsimonious has one
here and Michelle has recolors or Windkeeper's one
here. I would probably do it like this:
1. open up your custom mesh in Milkshape
2. extract and import EA's mesh (to use it as a guide) and then just remove the part over the hatch, so it's empty, like seen on the overlays linked above.
Also, there's an invisible wood recolor for the mailbox
here (or
here if you don't have M&G) which might be of interest to you, if your custom meshes are smaller than EA's mailbox's leg is for example :-)